|Quantity (Pack Size: 1)||Unit Price|
Minimum order Quantity Should be 1
DescriptionPowerbond Motor Vehicle Body Adhesive - 225
Technical DataChemical Basis: Epoxy Resin
Density: 1.1 g/cm3
Application temperature: +59?F to +77?F
Application time: 60 minutes*
Hardening Time: 4 hours*
Final strength: After 72 hours*
Shore D hardness (DIN 53505): 80
Tensile strength (ASTM D-638): 30 MPa*
Tensile shear strength (EN 1465): 1.7 MPa (after 4 hours)*, 13.3 MPa (after 8 hours)*, 19.0 MPa (after 17 hours)*
Resistant to: Fuels (petrol, diesel oil), motor and transmission oil, coolant
Thermal stability: -22?F to +248?F (for short peaks up to +374?F)
Shelf Life: 12 months
*measured at 73.4?F
High-strength two-component epoxy resin system for repairs to motor vehicle bodies.
High-strength epoxy resin adhesive
- The repair restores the original strength and stiffness.
- Fewer spot welds
- Meets the requirements of motor-vehicle manufacturers
- Even if strong pressure is exerted, an adhesive thickness of 0.7 to1.2 mm remains
- The adhesive will not run on vertical surfaces (thixotropic)
Excellent corrosion protection
- The original rust resistance is maintained
- Corrosion is prevented at welds
Can be through-welded
Can be ground and painted over
Free of silicone and VOC
Structural adhesive for steel, aluminum and fiber-reinforced plas-tics (FRP, CFRP). For gluing motor vehicle body parts such as side-walls, wheel arches, roof and door plates.
Not suited for load-bearing vehicle body parts (e.g. A-pillar, frame side bar). If body parts are only partially replaced, do not glue on visible surfaces since shadow seams may appear. Observe the vehicle manufacturer’s repair instructions.
This product can expose you to chemicals including Quartz, Carbon black , which are known to the State of California to cause cancer.
For more information go to: https://www.p65warnings.ca.gov/